|
|
|||
|
|
||
 |
 |
|
|
|||
Tape Hinges |
||||||
Stryker
Basics 2K Fun Stryker Build |
|
|||||
| How I do mine the ez way: I cut a piece of tape to length needed and apply it to elevon first so half the length is stuck to elevon, and other half will stick to trailing edge. Then I take the elevon and hold it flat against the trailing edge into position (but dont stick to trailing edge yet) the elevon needs to have max down travel. Take a clock for example: A centered elevon would be at 3 o,clock position, it needs to be around 4 o'clock position before sticking tape to trailing edge or the elevon wont have any down travel. For the bottom I cut a piece of tape to length needed and flipped over the elevon so it sits flat on top of wing and applied the tape like earlier but this time making sure the tape is formed tight and wrinkle free to area where the elevons bends, take a finger and run it down the gap between elevons and trailing edge to remove any wrinkles or tape that didnt stick as shown in center of pic above. Any loose or wrinkled tape in this area will cause problems later | ||||||
 |
 |
|
|
Contact
© 2005-2014 2KOOL4U.com
